Scoop has an Ethical Paywall
Licence needed for work use Learn More

Video | Agriculture | Confidence | Economy | Energy | Employment | Finance | Media | Property | RBNZ | Science | SOEs | Tax | Technology | Telecoms | Tourism | Transport | Search

 

TAIC Reports On Mid-air Collision Near Masterton, June 2019

The Transport Accident Investigation Commission (TAIC) has published its final report on a fatal mid-air collision near Hood Aerodrome, Masterton in June 2019.

A Cessna light aeroplane and a Tecnam microlight, each with only a pilot on board, were approaching to land at about the same time on parallel runways at Masterton. The Cessna was joining the circuit via a wide right turn for the left-hand runway, while the Tecnam was in the circuit approaching the right-hand runway and had right of way. The Tecnam was in front of the Cessna but very likely hidden below the Cessna’s engine.

The faster Cessna gained rapidly on the Tecnam and the overtaking Cessna impacted the right side of the Tecnam, striking it from above and behind. The two aircraft initially tangled before separating and spiralling to the ground. The two pilots died in the collision.

TAIC’s Chief Investigator of Accidents, Naveen Kozhuppakalam, says this accident happened because the Cessna did not give way to the Tecnam.

“The Cessna’s route to join the circuit was non-standard and disregarded civil aviation rules, but the pilot had been trained to do it this way in accordance with this accepted local practice at Hood Aerodrome.

“The Commission’s report underscores how vital it is that pilots keep a lookout for other aircraft, listen to radio calls from other planes, obey civil aviation rules, and follow standard operating procedures.

Turning to the broader circumstances that made this accident more likely, the Commission considered New Zealand’s busy local aerodromes with no air traffic control.

Advertisement - scroll to continue reading

“These unattended aerodromes are safe so long as they’re well managed by appropriately qualified ground staff, and everyone observes Civil Aviation Rules,” said Mr Kozhuppakalam.

“Safety depends not just on operators and pilots of aircraft, but also aerodrome owners, operators, managers and ground staff; they should all have appropriate training and support, with scrutiny and further support from safety regulators the Civil Aviation Authority and WorkSafe.”

The Commission found unattended aerodromes differed in their compliance with Civil Aviation Rules; in ‘simultaneous operations’ practice (planes taking off and landing on close parallel runways); and in observing the requirement to report safety incidents.

The Commission found aerodrome managers who lacked adequate training; the CAA delivered less regulatory oversight and support of non-certificated aerodromes compared to certificated aerodromes; and gaps in communication between the CAA, WorkSafe and local bodies about who should do what for safe operation of unattended aerodromes.

The Commission recommended that the CAA:

• Educate pilots about ‘simultaneous operations’ at unattended aerodromes and the common factors in mid-air collisions and the skills required to avoid them – such as actively listening to radio calls.

• Encourage reporting of safety-related incidents or concerns at unattended aerodromes.

• To ensure managers and users of unattended aerodromes fulfil their safety responsibilities: help WorkSafe, Local Government NZ, NZ Airports Association and other decision-makers; train and support aerodrome operational and management personnel; and encourage aerodrome user groups to get more involved in aerodrome safety.

TAIC has received a positive response from the Civil Aviation Authority, which has accepted and committed to address all of these recommendations .

© Scoop Media

Advertisement - scroll to continue reading
 
 
 
Business Headlines | Sci-Tech Headlines

 
 
 
 
 
 
 
 
 
 
 
 
 

Join Our Free Newsletter

Subscribe to Scoop’s 'The Catch Up' our free weekly newsletter sent to your inbox every Monday with stories from across our network.